Analysis on the operation and use of box boiling dryer

Operation and use of box boiling dryer :

1. Start the fan and check the tightness of the entire equipment after installation.

2. Open the steam valve of the box-type boiling dryer into the radiator and measure the inlet air temperature to the temperature required by the user.

3. Put the material into the star feeder and start the motor to get the material into the boiling bed.

4. Through the mirror window of the boiling bed, observe the boiling state and drying condition of the material in the boiling bed, adjust the opening size of the eight inlet pipes below the bed, and adjust to the good state of Zui.

5. After the material enters the boiling chamber, it must maintain a certain thickness of the material layer. Since the material automatically moves to the discharge port after entering the boiling chamber, the initial material is dried, and it needs to be discharged before being added to the feeder for drying. Material test, after the measured material contains water meets the requirements, it can be continuously fed and discharged. When using, control the amount of material added according to the specifications, performance, water content of different materials.

6. The cyclone separator and the discharge port and the trough at the lower part of the main unit should be discharged once, and the distribution plate in the bubbling bed should be cleaned once per shift.