Commissioning work when using the vegetable cutter

Many users don't know much about the structure and working principle of the cutting machine . They often come to consult. The following is a brief explanation by the technicians of Zhaoqing Fengxiang Catering Equipment Co., Ltd. , the debugging work when the cutting machine is used. What?

1. The structure of the vegetable cutting machine mainly consists of a frame, a conveyor belt, a pressing belt, a slicing mechanism, a speed control box or a tower wheel speed regulating mechanism.

2. Centrifugal slicing mechanism is used for the slicing of melon and potato hard vegetables. The thickness of the slice can be adjusted freely within a certain range. The vertical knife part can process leaf soft vegetables or cut pieces into different specifications of blocks, diamonds, etc. Various shapes. The length of the cut vegetables is arbitrarily adjusted within a certain range by the "adjustable eccentric wheel". Because the vertical knife simulates the principle of manual cutting, the processing surface is smooth and smooth, and the molding rules are fine. The vegetables are cut intact and kept fresh.

3. Try cutting before work, observe whether the specifications of the cut vegetables are the same as the required specifications, otherwise the slice thickness or the length of the cut vegetables should be adjusted, and the normal work should be carried out after meeting the requirements.

4. Install the vertical cutter for other cutting machine: first turn the adjustable eccentric wheel to make the knife holder go to the bottom dead center, then lift the knife holder up 1-2 mm, so that the vertical knife is in contact with the conveyor belt, tighten The nut fastens the vertical knife to the tool holder. Note: The height of the tool holder can be grasped according to the vegetables being cut. If the height of the knife holder is small, the vegetable may be connected with a knife; if the height of the knife holder is too large, the conveyor belt may be cut.

5. Length adjustment of cutting vegetables: Turn the adjustable eccentric wheel, loosen the connecting rod fastening screw, cut the filament to move the fulcrum, from the outside to the inside (the opening should face upward), and move the fulcrum when cutting the thick wire. Go out (the opening should face down at this time), tighten the adjusting screw after adjusting.